Extender
  • Extender Manual
  • Introduction
    • Safety Precautions
    • Specifications
    • Regulatory Compliance
    • What's in the box
    • External features
    • System requirements
  • Getting started
    • Syncing real-time clock
    • Updating firmware
    • Formatting SD Card
  • Modes of operation
    • Power only mode and Trigger Input
    • SD card recording mode
    • Pass-through mode
    • USB drive mode
  • Extender Details
    • Extender Button Functionality
    • Extender LED Functionality
    • Extender Charging
  • Hardware Triggering
    • Trigger Input & Cable
    • Example 1: 1s Pulses
    • Example 2: Serial Triggering
    • Example 3: MATLAB
  • Data Access
    • Downloading recordings
    • Decrypting recordings
    • Exported data format
  • Troubleshooting
    • Hardware Reset
Powered by GitBook
On this page
  1. Modes of operation

USB drive mode

PreviousPass-through modeNextExtender Details

Last updated 5 years ago

You can access the data on the microSD card without needing an external card reader. This is explained in the following steps:

  1. Turn Extender ON. The Status LED will turn green.

  2. Ensure no headsets are connected to Extender.

  3. Plug Extender into a PC, your computer should detect it as a generic USB drive and after a few moments you should see it appear as a drive. You can now access the encrypted files on the disk.

Note: All data stored to the SD card is encrypted and the EMOTIV App and a is required to decrypt the raw data.

PRO license