Extender
  • Extender Manual
  • Introduction
    • Safety Precautions
    • Specifications
    • Regulatory Compliance
    • What's in the box
    • External features
    • System requirements
  • Getting started
    • Syncing real-time clock
    • Updating firmware
    • Formatting SD Card
  • Modes of operation
    • Power only mode and Trigger Input
    • SD card recording mode
    • Pass-through mode
    • USB drive mode
  • Extender Details
    • Extender Button Functionality
    • Extender LED Functionality
    • Extender Charging
  • Hardware Triggering
    • Trigger Input & Cable
    • Example 1: 1s Pulses
    • Example 2: Serial Triggering
    • Example 3: MATLAB
  • Data Access
    • Downloading recordings
    • Decrypting recordings
    • Exported data format
  • Troubleshooting
    • Hardware Reset
Powered by GitBook
On this page
  1. Extender Details

Extender Button Functionality

Extender only has one button for both waking it up from sleep and recording. The table below outlines the behaviour.

Please note Extender will automatically sleep after 30 seconds if it is turned on but not connected with a headset or PC. Extender will automatically sleep if the battery is low and will blink the power LED before switching off.

The table below explains the push button behaviour:

Extender State

Button Press

New State

Off

Hold 3s

On

On

Hold 2s

Off

On

Momentary Press

Recording

Recording

Momentary Press

Stop Recording

PreviousExtender DetailsNextExtender LED Functionality

Last updated 5 years ago