Extender
  • Extender Manual
  • Introduction
    • Safety Precautions
    • Specifications
    • Regulatory Compliance
    • What's in the box
    • External features
    • System requirements
  • Getting started
    • Syncing real-time clock
    • Updating firmware
    • Formatting SD Card
  • Modes of operation
    • Power only mode and Trigger Input
    • SD card recording mode
    • Pass-through mode
    • USB drive mode
  • Extender Details
    • Extender Button Functionality
    • Extender LED Functionality
    • Extender Charging
  • Hardware Triggering
    • Trigger Input & Cable
    • Example 1: 1s Pulses
    • Example 2: Serial Triggering
    • Example 3: MATLAB
  • Data Access
    • Downloading recordings
    • Decrypting recordings
    • Exported data format
  • Troubleshooting
    • Hardware Reset
Powered by GitBook
On this page

Getting started

Before you start taking recordings with the Extender you want to ensure it is fully charged, running the latest firmware and the clock is updated. If you plan to record to a microSD card then you need to ensure the SD card is formatted as FAT32.

Instructions to do so are in the following pages.

PreviousSystem requirementsNextSyncing real-time clock

Last updated 6 years ago