EPOC Flex User Manual
  • EPOC FLEX User Manual
  • EPOC Flex
    • Introduction
    • Technical Specifications
    • Safety Precautions
    • Regulatory Compliance
    • Package Contents
    • Assembly Quick Start
  • Controller
    • Controller Details
    • Charging and LED Indicators
  • Electrodes
    • Example Sensor Placement (Montage)
    • Gel Sensors
    • Saline Sensors
  • Cap
    • EPOC Flex Cap
    • Choosing the Cap Size
  • Setup
    • Inserting the Sensors into the Cap
    • Inserting silicon skirts onto Sensors
    • Placing the Control Box
    • Positioning the Control Box
    • Working with Wires
    • Plugging the Cables into the Control Box
    • Custom Sensor Wiring
    • Gel Achieving high signal quality
  • Cleaning & Troubleshooting
    • Cleaning Gel Sensors & Cap
    • Storage
    • Troubleshooting
Powered by GitBook
On this page
  1. Setup

Plugging the Cables into the Control Box

PreviousWorking with WiresNextCustom Sensor Wiring

Last updated 5 years ago

Plug the white connector (attached to all your red cables) into the right hand side of the control box. The connector only fits in one way, so if it fits in, then you have successfully connected your control box! Repeat the process for the left side (blue cables).

Double check all your cables are in the right place – you are almost ready for recording!

Plugging the cables