EPOC X User Manual
  • EPOC X
  • Warranties and Copyright
  • Regulatory compliance
  • Introduction
    • Introduction to EPOC X
      • Coverage
    • Application compatibility
    • Technical specifications
    • Safety precautions
  • Getting started
    • Package contents
    • Charging your EPOC X
      • Charging behaviour
    • Turning your headset on
    • Hydrating the sensor felts
      • Further saline solution
    • Fitting the sensor felts
    • Changing reference sensor location
    • Connecting your EPOC X to a device
      • Connecting your EPOC X using the USB receiver dongle
        • USB receiver dongle behaviour
      • Connecting your EPOC X using Bluetooth Low Energy
    • Fitting your EPOC X
      • How to achieve the best contact quality
  • Storing your EPOC X
    • Storing your EPOC X when not in use
  • Support
    • Firmware
    • EMOTIV Support
Powered by GitBook
On this page
  1. Storing your EPOC X

Storing your EPOC X when not in use

PreviousHow to achieve the best contact qualityNextFirmware

Last updated 5 years ago

When your EPOC X is not in use, remove all the sensor felts from the headset and allow them to dry out before storing them. Do not leave the sensor felts in the sensors. Leaving wet sensor felts in the sensors will corrode the electrodes. Store used sensor felts separately to unused ones.

To keep the headset in optimum condition please rinse the sensors with sterile water after use to remove excess salt. EPOC X’s electrodes are electroplated and keeping them clean will minimise corrosion.

Store your EPOC X in the travel case provided.

Replacement sensor felt packs can be purchased from the EMOTIV

online store