EPOC X User Manual
  • EPOC X
  • Warranties and Copyright
  • Regulatory compliance
  • Introduction
    • Introduction to EPOC X
      • Coverage
    • Application compatibility
    • Technical specifications
    • Safety precautions
  • Getting started
    • Package contents
    • Charging your EPOC X
      • Charging behaviour
    • Turning your headset on
    • Hydrating the sensor felts
      • Further saline solution
    • Fitting the sensor felts
    • Changing reference sensor location
    • Connecting your EPOC X to a device
      • Connecting your EPOC X using the USB receiver dongle
        • USB receiver dongle behaviour
      • Connecting your EPOC X using Bluetooth Low Energy
    • Fitting your EPOC X
      • How to achieve the best contact quality
  • Storing your EPOC X
    • Storing your EPOC X when not in use
  • Support
    • Firmware
    • EMOTIV Support
Powered by GitBook
On this page
  1. Getting started

Hydrating the sensor felts

PreviousTurning your headset onNextFurther saline solution

Last updated 4 years ago

Hydrating The Sensor Felts To hydrate the sensor felts, place them in a glass then add the saline solution and soak. When the sensor felts are fully soaked, remove them from the glass and squeeze out the excess fluid. They are now ready to be inserted into the sensors.

Rehydrating the sensor felts while the headset is in use If you need to rehydrate the sensor felts while the headset is being worn, you can add saline solution to each individual sensor felt using the opening at the top of each sensor. This feature enables you to continue using the headset and not disturb your session.