EPOC X User Manual
  • EPOC X
  • Warranties and Copyright
  • Regulatory compliance
  • Introduction
    • Introduction to EPOC X
      • Coverage
    • Application compatibility
    • Technical specifications
    • Safety precautions
  • Getting started
    • Package contents
    • Charging your EPOC X
      • Charging behaviour
    • Turning your headset on
    • Hydrating the sensor felts
      • Further saline solution
    • Fitting the sensor felts
    • Changing reference sensor location
    • Connecting your EPOC X to a device
      • Connecting your EPOC X using the USB receiver dongle
        • USB receiver dongle behaviour
      • Connecting your EPOC X using Bluetooth Low Energy
    • Fitting your EPOC X
      • How to achieve the best contact quality
  • Storing your EPOC X
    • Storing your EPOC X when not in use
  • Support
    • Firmware
    • EMOTIV Support
Powered by GitBook
On this page
  1. Getting started
  2. Connecting your EPOC X to a device

Connecting your EPOC X using the USB receiver dongle

PreviousConnecting your EPOC X to a deviceNextUSB receiver dongle behaviour

Last updated 5 years ago

The USB receiver dongle uses a proprietary 2.4 GHz protocol to stream data from your headset.

We recommend that you use the USB receiver dongle in environments with high levels of Bluetooth interference.

  1. Insert the USB receiver dongle into the USB port of your PC or Mac. When the USB receiver dongle is inserted into the port, one LED will light up.

  2. Press the power button on the headset. The headset will then beep and the LED next to the power button will turnwhite.

  3. After the headset is turned on, a second LED on the USB receiver dongle will light up and start to flash. Your headset and USB receiver dongle are now connected.

For further information on setting up the connection with your chosen EMOTIV application, please refer to the relevant user manual.