The number of sensors and wire positions fitted to the connectors is flexible. As a default, all 32 sensors + 2 reference sensors are fitted to the two connectors.
On the left-hand side are 16 blue sensor wires and the black CMS wire.
On the right-hand side are 16 red sensor wires and the black DRL wire.
The sensor names (A-Q) match the pin positions (A-Q) on the connector, as shown below.
Each connector has an empty position above the black reference wires. The connectors are standard 18-position, but only 17 positions are loaded with wires.
Please do not insert the connector into the empty position.
Sensors that you don’t need for your experimental montage can be removed.
To remove unneeded sensors:
Use a thin-flat screwdriver or tweezers to lift up the connector’s plastic tab(s). Lifting the tab will release the crimp locking mechanism.
Pull the wire until you see the gold color of the crimp.
Then, remove the reference wire.
To insert a sensor wire to the connector:
Place the crimp lock upwards, then
Insert the wire and then pull it to ensure it’s locked in place.