FLEX 2.0 User Manual
  • FLEX
  • Warranties and Copyright
  • Regulatory Compliance
  • Introduction
    • Introduction to FLEX
    • Application Compatibility
    • Technical Specifications
    • Safety Precautions
  • Getting Started
    • FLEX Package Contents
    • FLEX Controller
    • Charging FLEX
    • Turning FLEX On
  • FLEX Wires and Sensors
    • FLEX Wires
    • FLEX Gel Sensor Kit
    • FLEX Saline Sensor Kit
  • FLEX Cap
    • FLEX Cap
    • Choosing the Right FLEX Cap
    • Pre-Configured Saline FLEX Cap
  • Setting Up FLEX Cap
    • Inserting Sensors
    • Fitting FLEX Cap to a Participant
    • Positioning the FLEX Controller
    • Tidying the Wires and Minimizing Motion Artifacts
    • Connecting the Sensors to the FLEX Controller
    • Customizing the Sensor Wires
  • Achieving High EEG Signal Quality
    • Gel Sensors
    • Saline Sensors
  • Cleaning
    • Cleaning the FLEX Cap
    • Cleaning the FLEX Cap and Gel Sensors Together
    • Cleaning Gel Sensors
    • Cleaning Saline Sensors
  • Storage
    • Storing FLEX
  • Support
    • Replacement Saline Sensor Felts
    • Troubleshooting
    • EMOTIV Support
Powered by GitBook
On this page
  1. Setting Up FLEX Cap

Tidying the Wires and Minimizing Motion Artifacts

PreviousPositioning the FLEX ControllerNextConnecting the Sensors to the FLEX Controller

Last updated 1 year ago

To minimize motion artifacts during your experiments, keeping excess wires secured to reduce their movements is essential. Once you've fitted all the sensors to the FLEX Cap, we recommend using the tagger pins and tagger tool (supplied with your FLEX kit) to tidy up the wiring by 'sewing' them into place. Another option is to place a shower cap, another Flex Cap, or a swimming cap over the top of the FLEX Cap to minimize wire movements.

Tagger pins and tool

How to Tidy the Wires