FLEX 2.0 User Manual
  • FLEX
  • Warranties and Copyright
  • Regulatory Compliance
  • Introduction
    • Introduction to FLEX
    • Application Compatibility
    • Technical Specifications
    • Safety Precautions
  • Getting Started
    • FLEX Package Contents
    • FLEX Controller
    • Charging FLEX
    • Turning FLEX On
  • FLEX Wires and Sensors
    • FLEX Wires
    • FLEX Gel Sensor Kit
    • FLEX Saline Sensor Kit
  • FLEX Cap
    • FLEX Cap
    • Choosing the Right FLEX Cap
    • Pre-Configured Saline FLEX Cap
  • Setting Up FLEX Cap
    • Inserting Sensors
    • Fitting FLEX Cap to a Participant
    • Positioning the FLEX Controller
    • Tidying the Wires and Minimizing Motion Artifacts
    • Connecting the Sensors to the FLEX Controller
    • Customizing the Sensor Wires
  • Achieving High EEG Signal Quality
    • Gel Sensors
    • Saline Sensors
  • Cleaning
    • Cleaning the FLEX Cap
    • Cleaning the FLEX Cap and Gel Sensors Together
    • Cleaning Gel Sensors
    • Cleaning Saline Sensors
  • Storage
    • Storing FLEX
  • Support
    • Replacement Saline Sensor Felts
    • Troubleshooting
    • EMOTIV Support
Powered by GitBook
On this page
  1. Setting Up FLEX Cap

Connecting the Sensors to the FLEX Controller

PreviousTidying the Wires and Minimizing Motion ArtifactsNextCustomizing the Sensor Wires

Last updated 1 year ago

Take the white connector at the end of the red wires and plug it into the right-hand side of the FLEX controller. Repeat this process for the blue wires on the left-hand side.

Once you've plugged the wires into FLEX, double-check that they're all in the right place.

Connector and blue wires on the right-hand side of the FLEX Cap

Connector and blue wires on te left-hand side of the FLEX Cap