FLEX 2.0 User Manual
  • FLEX
  • Warranties and Copyright
  • Regulatory Compliance
  • Introduction
    • Introduction to FLEX
    • Application Compatibility
    • Technical Specifications
    • Safety Precautions
  • Getting Started
    • FLEX Package Contents
    • FLEX Controller
    • Charging FLEX
    • Turning FLEX On
  • FLEX Wires and Sensors
    • FLEX Wires
    • FLEX Gel Sensor Kit
    • FLEX Saline Sensor Kit
  • FLEX Cap
    • FLEX Cap
    • Choosing the Right FLEX Cap
    • Pre-Configured Saline FLEX Cap
  • Setting Up FLEX Cap
    • Inserting Sensors
    • Fitting FLEX Cap to a Participant
    • Positioning the FLEX Controller
    • Tidying the Wires and Minimizing Motion Artifacts
    • Connecting the Sensors to the FLEX Controller
    • Customizing the Sensor Wires
  • Achieving High EEG Signal Quality
    • Gel Sensors
    • Saline Sensors
  • Cleaning
    • Cleaning the FLEX Cap
    • Cleaning the FLEX Cap and Gel Sensors Together
    • Cleaning Gel Sensors
    • Cleaning Saline Sensors
  • Storage
    • Storing FLEX
  • Support
    • Replacement Saline Sensor Felts
    • Troubleshooting
    • EMOTIV Support
Powered by GitBook
On this page
  1. FLEX Wires and Sensors

FLEX Gel Sensor Kit

PreviousFLEX WiresNextFLEX Saline Sensor Kit

Last updated 1 year ago

The FLEX gel kit includes 34 multi-rode gel sensors. The sensors are made from sintered Silver/Silver Chloride to minimize sensor impedance and ensure they are fully compatible with gel electrolytes. Each sensor wire is crimped and fitted to the connector housing. The wires are labeled A-G and J-Q.

Multi-rode gel sensor

Ear Clips

The FLEX Gel Kit includes two ear clips to hold the sensors in place on the ears. The clips can be removed once the gel has hardened on the ears.