FLEX 2.0 User Manual
  • FLEX
  • Warranties and Copyright
  • Regulatory Compliance
  • Introduction
    • Introduction to FLEX
    • Application Compatibility
    • Technical Specifications
    • Safety Precautions
  • Getting Started
    • FLEX Package Contents
    • FLEX Controller
    • Charging FLEX
    • Turning FLEX On
  • FLEX Wires and Sensors
    • FLEX Wires
    • FLEX Gel Sensor Kit
    • FLEX Saline Sensor Kit
  • FLEX Cap
    • FLEX Cap
    • Choosing the Right FLEX Cap
    • Pre-Configured Saline FLEX Cap
  • Setting Up FLEX Cap
    • Inserting Sensors
    • Fitting FLEX Cap to a Participant
    • Positioning the FLEX Controller
    • Tidying the Wires and Minimizing Motion Artifacts
    • Connecting the Sensors to the FLEX Controller
    • Customizing the Sensor Wires
  • Achieving High EEG Signal Quality
    • Gel Sensors
    • Saline Sensors
  • Cleaning
    • Cleaning the FLEX Cap
    • Cleaning the FLEX Cap and Gel Sensors Together
    • Cleaning Gel Sensors
    • Cleaning Saline Sensors
  • Storage
    • Storing FLEX
  • Support
    • Replacement Saline Sensor Felts
    • Troubleshooting
    • EMOTIV Support
Powered by GitBook
On this page
  1. Cleaning

Cleaning the FLEX Cap

You can clean the FLEX Cap in a washing machine at 30°c (86°F/warm setting) using a mild detergent. When it’s clean, allow it to air dry.

You can also hand wash the FLEX Cap with a mild detergent, such as children’s shampoo. After handwashing it, rinse the FLEX Cap with clean water, then remove excess water with a paper towel and air dry.

Do not put the FLEXCap in the dryer.

Do not iron the FLEXCap.

Do not disinfect or bleach the FLEXCap. Strong oxidizing agents or bleach can reduce the life of the FLEXCap.

PreviousSaline SensorsNextCleaning the FLEX Cap and Gel Sensors Together

Last updated 1 year ago